Square Crossflow Cooling Tower
Air enters from both sides and travels horizontally across the falling water while an induced-draft fan on top discharges warm, moist air. Gravity distribution, low pump head and easy access make the square crossflow cooling tower a first choice for HVAC and industrial process water.

The square crossflow cooling tower uses two-sided air inlet and a top-mounted axial fan. Air passes through the fill on both sides of the tower and exchanges heat with the hot water before being discharged to atmosphere. The fill uses double-sided dimpled point-wave sheets bonded into an integral block for rigidity; the dimples prevent direct droplet fall-off and improve film formation, while a water collection device at the fill tail limits drift.
A purpose-designed high-efficiency heat-exchange fill increases the effective contact area, so the footprint and operating weight are substantially reduced. Low air-resistance fill combined with an airfoil-profile FRP axial fan keeps motor power low; two-speed or VFD motors are available for part-load energy savings. Low-noise FRP fans and dedicated low-noise motors reduce operating sound, and super-low-noise versions are available for noise-sensitive sites.
Modular cells can be combined to match almost any duty, and the exterior can be adapted to the surrounding architecture. Adjacent air chambers are isolated, so fill cleaning, basin flushing and distribution maintenance can be carried out while other cells stay in operation.
Key advantages
Compact footprint
Optimised fill and steel structure reduce plan area and operating weight versus conventional towers.
Lower fan power
Low-resistance fill + airfoil FRP axial fan; optional two-speed or VFD drive.
Low operating noise
Purpose-designed FRP low-noise fans and motors; super-low-noise series available.
Modular configuration
Multi-cell arrangements and exterior finishes adapted to site layout.
Service-friendly
Isolated air chambers allow maintenance while the remaining cells run.
Specification & configuration
| Airflow arrangement | Crossflow, induced draft, two-sided air inlet |
|---|---|
| Circuit | Open circuit / direct evaporative cooling |
| Distribution | Gravity-fed hot water basin, low pump head |
| Fill media | Dimpled point-wave PVC sheets, integral bonded blocks |
| Structure | Corrosion-protected steel frame with FRP casing options |
| Capacity | Project-specific thermal selection — single cell to multi-cell banks |
| Options | Low / super-low noise, two-speed or VFD motor, high-temperature fill, custom colour, PLC control |
Typical applications
- HVAC & chiller condenser water
- Commercial buildings, hospitals, hotels
- Petrochemical and chemical process cooling
- Power generation auxiliaries
- Light and general industrial process water
Product gallery
Tell us about your cooling duty
Share your flow rate, inlet / outlet water temperature and design wet-bulb temperature — we will size the right tower for you.
Talk to a cooling tower engineer
Technical selection, drawings and a quotation — usually within one business day.


